Pictured at Right: A set of variegated earthtone potholders.
These potholders are crocheted in two different colors of variegated yarn for a rich, vibrant effect. The potholders look much more complex than they really are; the color changes are all easy ones. The variegated yarns do a great deal of the colorwork for you.
The potholders are crocheted using afghan stitch, otherwise known as Tunisian simple stitch.
See a larger photo.
For each potholder, you’ll need a total of approximately 3 oz. of worsted weight cotton yarn, evenly divided between two colors. The sample was worked in Peaches & Creme cotton yarn. Feel free to substitute any similar cotton yarn if you prefer. The colors used in the sample potholders are as follows:
- Shaded Brown (Color A)
- Earth Tone (Color B)
For the Body of the Potholder: You’ll need a size J / 10 /6.0 mm afghan crochet hook measuring 10+ inches long, or your preferred size.
For the Edging: An ordinary J hook is a good starting point, but you may need to adjust up or down if you notice a significant difference in tension.
Other: Tapestry needle and safety pins
Afghan Stitch Note:
Work in afghan stitch.
Row 1: Use Color A for the forward pass, and switch to color B for the return.
Row 2: Use Color B for the forward pass, and switch to color A for the return.
Rows 3 and Above: Repeat rows 1-2 until you’ve created a square. After about row 25, measure your work periodically to check the progress.
When your piece is square, work one slip stitch in each vertical bar all the way across the row. (29 slip stitches worked.)
Work 2 of these squares for each potholder you want to make. If you’d like to make a matching pair of potholders, you’ll need four squares all together.
Finishing the Squares:
The edging is worked in the round, and it is created using single crochet and slip stitches. The edging is used to hold the two pieces of the potholder together.
Ch 2 using the ball of yarn attached to a potholder square.
Place the wrong sides of the squares together. The “face” of the fabric is the side that was facing you as you were crocheting each square. You want these sides facing outwards. Be sure that you hold both the top edges together, as there is one stitch less on the top than the bottom.
You might find it helpful to safety pin the corners of the squares to help you hold them together as you join them.
Working through the front and back loops of both squares, work one single crochet stitch in each stitch, all the way around. When you get to the corners: (sc, ch 2, sc in the same stitch) and then continue working sc. At the end of the round, ch 12 to make the hanging loop for the potholder. Join the hanging loop to the body of the potholder with a slip stitch.
Work 1 slip stitch in each sc all the way around. When you get to the corners, work a slip stitch into the the ch-2 corner space. When you’ve worked slip stitches all the way around the potholder, end off, leaving a tail of yarn at least 6 inches long.
Weave in the end carefully using a tapestry needle. Your work will be visible, so be as neat as you can about it.
After you’ve woven in 4+ inches of the tail of yarn, you can hide the end in between the layers of the potholder:
- Insert your hook in between the layers of the potholder, starting from a spot in the middle.
- Bring the hook up to the surface again in a spot that is really close to the tail of yarn.
- Grab the tail of yarn with the hook.
- Pull it through one layer of the potholder.
- Carefully extricate your hook, leaving the tail of yarn buried inside the potholder.
Matching Earthtone Dishcloth Pattern
There are several other versions of this potholder that you might also like to try. They all end up looking different, but the basic design is the same: